We provide design assistance for lighting, controls and energy audits. Just give us a little info and our lighting designers
will start work on your project.
If you are unsure of your local distributor,
you may use the Where to Buy page to locate the
one nearest you.
Budgetary Amount is used to determine Lighting Design resources required (e.g. Lighting Design, Tech Support, Rep Agency, Other).
In an effort to answer the high demand of this free lighting design service we typically aim for a 5 day turn around. If
your deadline is sooner, please call us at (888) 722-1000 after submitting this form, and ask to speak with a lighting
Local Ordinances can greatly effect a lighting design and may include requirements governing light trespass (amount of light over the property line), light pollution (light spilled into the night sky), maximum mounting heights, uniformity and potentially other design parameters that should be taken into consideration during design phase. We kindly ask that you help us reduce the number of revisions to your project by looking into any applicable ordinances that might affect its design prior to us beginning the design. We appreciate your assistance in helping us turn more free lighting design projects around!
If you need to retrofit an existing installation, please provide us with the existing locations by attaching any drawings, sketches, or photographs.
Please provide a mounting height/ ceiling height (in feet and inches) for your project. Your request cannot be processed without this information and may cause delays in turnaround time.
Please provide a full drawing set containing RCPs, luminaire schedule, lighting control
schedule, load schedule and one-line diagrams.Site information, building materials and
architectural plans also help. Please provide Division 26 – Electrical specifications
includinglighting control device info, Sequence of Operations documentation and the
luminaire specifications. We design control systems basedon the relevant ASHRAE 90.1 or
IECC code in the state where your project is located.
Lightcloud and Lightcloud Blue control requests are fulfilled with two separate
Due to the additional complexity with any controls request, completion time will vary by
This is an average cost normalizing demand and surcharges plus and utility service fees, assume $0.14 per kWh
Daily hours of operation, days per week of operation, weeks per year of operation, assume 10/7/52
Include wattages if known. Otherwise, we will determine this based on your fixture description. If you have a RAB catalog number, please provide it.
If we are designing a proposal, we only need the base system info. Please note that most times, the best every saving can be shown from a redesigned system and not on a one-for-one replacement.
If this is not supplied, we will make the following assumptions:
• $100.00 per hr. for metroplex/urban areas
• $75.00 per hr. for sub-urban areas
• $60.00 per hr. for rural areas
We assume based on fixture type and application requirements. Typical assumption is $10.00 per fixture.
We assume $0.00 unless otherwise stated.
In a few minutes, you will receive an automated e-mail from us to confirm that we've received your request.
If you do not receive this e-mail, please check your spam folder. If our automated response is delivered to
your spam folder, any future correspondence will appear there as well. If you do not receive the confirmation
email, we likely do not have your request. Please contact Lighting Design to confirm before resubmitting.